Is there ONE Command to enable full duplex in Cisco 2960

Hi All,

How to enable Full Duplex in all the ports of Cisco 2960 in ONE Command. Also without connecting to console is there any way to connect Cisco 2960 when it is in unmanaged status.

Looking forward your reply, Thanks in Advance.

Rizin

Not quite; but I think you can do it in two. For example:
interface range fa0/1 - 24
duplex full

Also without connecting to console is there any way to connect Cisco 2960 when it is in unmanaged status.

If you mean you want to configure the switch without using console, then most of those switch models have a web interface (device manager), you need the command ip http server. If this is what you need, I can give you further info if you want.

Sorry for the late reply folks,

2960 is connected to the lan network 192.168.1.0 network, My PC is connected to the same network, In this case can i able to access 2960 without configuring it, i guess by default 2960 switch is in the unmanaged state. so in this case ip also not been configured. considering above suitation how can i access 2960 switch from my PC.

Thanks Much !

I suppose a console cable is out of the question?

hi.

sorry to say that I prefer not to use Console and i would like to know it for my learning purposes.

Thanking you in advance for your help.

Rizin