Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: How to configure a PIX to receive IP from Linksys router?

How to configure a PIX to receive IP from Linksys router? 14 years 3 days ago #6352

  • saidfrh
  • saidfrh's Avatar Topic Author
  • Offline
  • Distinguished Member
  • Distinguished Member
  • Posts: 92
  • Thank you received: 0
What is the config for a PIX to allow hosts access the internet? The PIX sits behind a Linksys router with DHCP. The folowing config does not work.

PIX(config )# interface ethernet0 10baset
interface ethernet1 10full
ip address outside dhcp setroute
global (outside) 1 interface
nat (inside) 1 0.0.0.0 0.0.0.0
ip address inside 10.10.1.1 255.255.255.0


Config on PC
Ip address 10.10.1.2/24
default gateway 10.10.1.1

Re: How to configure a PIX to receive IP from Linksys router? 14 years 19 hours ago #6383

  • sidd
  • sidd's Avatar
  • Offline
  • Frequent Member
  • Frequent Member
  • Posts: 34
  • Thank you received: 0
HI

Try settin the outisde interface on auto and then reload the router and the pix firewall. first switch on the router and then turn on the pix firewall. give the command ip address outside dhcp setroute again and it should work if it does not then make the outside interface on auto and then repeat the process...



sidd
  • Page:
  • 1
Time to create page: 0.123 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup