Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: a problem of cisco 3500 switch

a problem of cisco 3500 switch 13 years 6 months ago #139

  • windmen
  • windmen's Avatar
  • Offline
  • New Member
  • Posts: 2
  • Karma: 0
I use cisco 3500 switch. I know that I can config the duplex and speed of every interface, using the commands as list:
#interface fa 0/1
#speed 100
#duplex full

but I want to know how could I deal with a group of interfaces, like interface 0/1 to 0/12, using one or two commands, instead of operate above twelve times.

does it exist these commands?
You will never walk alone...
From Anfield, Liverpool
The administrator has disabled public write access.

a problem of cisco 3500 switch 13 years 4 months ago #140

  • netNewbie
  • netNewbie's Avatar
  • Offline
  • New Member
  • Posts: 6
  • Karma: 0
As much as I know, there is no such command. Try interface fa 0/2 ?, you'll see that the only option after that is <cr>. That means that you gotta do it one by one.
However, you can edit a text file (copy & paste), then send it through the hyperterminal, assuming you're using Windoz. If you are not using Windoz, there gotta be something similar to hyperterminal though.

Newbie
The administrator has disabled public write access.

a problem of cisco 3500 switch 13 years 4 months ago #141

  • Chris
  • Chris's Avatar
  • Offline
  • Administrator
  • Posts: 1446
  • Thank you received: 13
  • Karma: 8
Windmen,

To the best of my knowledge, this is not possible.

You will need to configure each interface individually

Cheers,
Chris Partsenidis.
Founder & Editor-in-Chief
www.Firewall.cx
The administrator has disabled public write access.
Time to create page: 0.077 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup