Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: basic configurations to a 3560

basic configurations to a 3560 10 years 10 months ago #11352

  • little_me
  • little_me's Avatar
  • Offline
  • New Member
  • Posts: 1
  • Karma: 0
could anyone help,
i configured a cisco 3560 for the most simplest basic commands

config t
inter vlan
ip adress 10.230.19.3 255.255.255.0
full duplex
speed 100
no shut
wr mem

I am missing something because when i plug it in another switch (diasy chain) all the led on that switch are all FLASHING, and the network is down. lol

should i specify default ip address, enable ip routing, no switchport????

please help...
your truely,
little me
The administrator has disabled public write access.

Re: basic configurations to a 3560 10 years 10 months ago #11353

  • Chris
  • Chris's Avatar
  • Offline
  • Administrator
  • Posts: 1446
  • Thank you received: 13
  • Karma: 8
If its not too much trouble, can you paste the whole configuration?
Chris Partsenidis.
Founder & Editor-in-Chief
www.Firewall.cx
The administrator has disabled public write access.

Re: basic configurations to a 3560 10 years 10 months ago #11358

  • tiamat
  • tiamat's Avatar
  • Offline
  • Distinguished Member
  • Posts: 102
  • Karma: 0
If those were the only configuration steps you did, then nothing that gets plugged into the new 3560 should be able to access the network, as the interfaces are most likely in a shutdown state. All you've done so far is given the vlan interface an ip address and enabled it (no shut). I'm pretty sure all the interfaces will be in shutdown by default.

As for the flashing lights on the other switch, you didn't mention what kind of switch it is or its config, so I can't say.
The administrator has disabled public write access.
Time to create page: 0.083 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup