Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: How to make port security in Cisco 2950

How to make port security in Cisco 2950 9 years 9 months ago #20107

  • bangjdi
  • bangjdi's Avatar
  • Offline
  • New Member
  • Posts: 4
  • Karma: 0
Hi,
Could you help me,

please guide me to create port security for interface in Cisco 2950,

i want to make 1 static mac address in 1 interface, and only static mac

address can make connection to switch.

i tried :
Switch(config)# mac-address-table static 0010.b5e1.ecf5 vlan 1 interface FastEthernet0/5

to make static mac address in interface 5

so, waht should i do to make port security enable ?
The administrator has disabled public write access.

Re: How to make port security in Cisco 2950 9 years 9 months ago #20110

  • TheBishop
  • TheBishop's Avatar
  • Offline
  • Moderator
  • Posts: 1719
  • Thank you received: 8
  • Karma: 5
Switch)# config t
Switch(config)# int fa0/12
Switch(config-if)# switchport port-security ?
aging Port-security aging commands
mac-address Secure mac address
maximum Max secure addresses
violation Security violation mode

The default form of the command locks you to one MAC address anyway:

Switch(config-if)# switchport port-security
Switch(config-if)#^Z

For more info have a look at http://www.zdnetasia.com/insight/network/0,39044847,61959170,00.htm
The administrator has disabled public write access.
Time to create page: 0.072 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup