Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: Connection issues Cisco 851W and WPS54G

Connection issues Cisco 851W and WPS54G 7 years 7 months ago #29638

  • r0nni3
  • r0nni3's Avatar
  • Offline
  • Distinguished Member
  • Posts: 107
  • Karma: 0
Recently i bought a Cisco 851W to replace a Linksys router for a customer.
The wireless connection between the router and printserver were fine before i replaced the linksys with a Cisco. But when i implemented the Cisco router things started to go wrong.
The wireless connection with the print server drops multiple times per day and requires a reboot from both the router and printserver to get it back online.

Here's the config that matters on the Cisco 851W:

dot11 ssid *
vlan 1
authentication open
authentication key-management wpa
infrastructure-ssid optional
wpa-psk ascii 0 *
interface Dot11Radio0
no ip address
encryption mode ciphers tkip
encryption vlan 1 mode ciphers tkip
ssid *
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root
interface Dot11Radio0.1
encapsulation dot1Q 1 native
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
interface Vlan1
no ip address
ip virtual-reassembly
bridge-group 1
interface BVI1
ip address
ip nat inside
ip virtual-reassembly
no ip route-cache cef
no ip route-cache

Any help is greatly appreciated.

Thank you in advance!
Currently working as Cisco Engineer at Neon-Networking.

CCNA - Have it
CCNA Security - Have it
CCSP - Almost!!!!
CCIE Security - Not so far away dream
The administrator has disabled public write access.

Re: Connection issues Cisco 851W and WPS54G 7 years 7 months ago #29644

  • S0lo
  • S0lo's Avatar
  • Offline
  • Moderator
  • Posts: 1577
  • Thank you received: 7
  • Karma: 3
I assume here that you have other clients that are connecting to the Cisco 851W wirelessly and that none of them encountered the same problem.

Here is one theory :roll:. Are you using DHCP for the internal clients? (It's not clear from the config). If you are, then I assume the print server is using a static IP. Then have you excluded the print server's IP from the 851W's DHCP config. If not, then the 851W might try to give that IP to other clients which obviously can cause conflicts.

Or, I might be totally out of the scope of the problem here. Just a try.
Studying CCNP...

Ammar Muqaddas
Forum Moderator
The administrator has disabled public write access.
Time to create page: 0.074 seconds


Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V


  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup