when trying to config per cisco website with info below command:
"bundle-enable" errors out and is not listed in help
"interface ATM0.1 point-to-point" errors out. there is no help listing. Only ATM port I have is ATM0/0.
Trying to config to talk to my ISP.
Cisco web info:
no vpdn logging
!--- You are the PPPoE client that asks to establish a session
!--- with the aggregation unit (6400 NRP). These VPDN commands
!--- are not needed with Cisco IOS Software Release 12.2(13)T
!--- or later.
!--- Internal Ethernet network.
ip address 10.92.1.182 255.255.255.0
ip nat inside
!--- DSL interface.
no ip address
no atm ilmi-keepalive
dsl operating-mode auto
hold-queue 224 in
!--- All defaults.
!--- PPPoE runs on top of AAL5SNAP. However, the
!--- encap aal5snap command is not used.