Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: How to tclsh in packet tracer 5.1

Re: How to tclsh in packet tracer 5.1 9 years 9 months ago #31353

I have another problem now... I want to start ping with high repeat
but this command also can't execute

R3# ping 10.1.1.1 repeat 100000

this is the error

R3#ping 10.1.1.1 repeat 100000
^
% Invalid input detected at '^' marker.

Re: How to tclsh in packet tracer 5.1 9 years 9 months ago #31356

At priveliged exec mode, type:
ping
<cr>
IP
<cr>
xxx.xxx.xxx.xxx (the address you want to ping)

Then you get the prompt "Repeat Count[5]?
This is where you set the number of pings you want. Simply type a number...

Then <cr> through until you get to the end and pings will start. [ctrl][shift][6] will stop them if you don't want to wait for all the pings to complete.
  • Page:
  • 1
  • 2
Time to create page: 0.093 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup