Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: DHCP in PT 4.0

DHCP in PT 4.0 9 years 11 months ago #17595

  • joshtcom
  • joshtcom's Avatar
  • Offline
  • New Member
  • Posts: 1
  • Karma: 0
I'm new to the whole networking thing but I'm reading a Todd Lammle CCNA book. I was wondering if someone could explain to me how to use DHCP in Packet Tracer 4.0? I've set up a few networks in PT, but can't figure out the commands to make DHCP work. Any help would be appreciated
CCWB (Cisco Certified Wanna-Be)
The administrator has disabled public write access.

Re: DHCP in PT 4.0 9 years 10 months ago #18085

  • S0lo
  • S0lo's Avatar
  • Offline
  • Moderator
  • Posts: 1577
  • Thank you received: 7
  • Karma: 3
Try something like this on a router:

ip dhcp excluded-address 192.168.2.1

ip dhcp pool TEST
network 192.168.2.0 255.255.255.0
default-router 192.168.2.1

I tried this config on the ccna_12.pkt topology file on the "Vargas" router and it works. And ofcourse don't forget to issue the "ipconfig /renew" command on the PCs
Studying CCNP...

Ammar Muqaddas
Forum Moderator
www.firewall.cx
The administrator has disabled public write access.

Re: DHCP in PT 4.0 6 years 2 weeks ago #35456

All the needed information for configuring DHCP on Packet Tracer is on
http://www.packettracernetwork.com/dhcpconfiguration.html
The administrator has disabled public write access.
Time to create page: 0.075 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup