Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: NAT on Frame Relay

NAT on Frame Relay 12 years 1 month ago #16171

  • Dove
  • Dove's Avatar Topic Author
  • Offline
  • Distinguished Member
  • Distinguished Member
  • Posts: 198
  • Karma: 2
  • Thank you received: 1
Hi,
I am preparing for my CCNA. I am using the Boson Netsim. In my network there are four router connected into the Frame relay cloud. EIGRP routing is running on each router. Each routers are able to ping with each other.

After that I gave the follwoing command for NATing on Router1


ip nat pool p1 192.168.0.1 192.168.0.255
ip nat inside source list 1 pool p1

access-list 1 permit 192.168.0.0 0.0.0.255

r1(Config)int f0/0
r1(Config-if)ip nat inside
r1(Config)int s0/0
r1(Config-if)ip nat outside

when I checked after configuring this I found that the NAT was not working.

even the sh ip nat trans also blank.


Please some one help how to configure the NAT on Frame Relay network.

Note : The same Nat Configuration is working well if the router are connected through the Serial ports (Directly connected).


Thanks in advance

Regards,
Dove

Dove

Re: NAT on Frame Relay 11 years 5 months ago #20883

  • krik
  • krik's Avatar
  • Offline
  • Frequent Member
  • Frequent Member
  • Posts: 69
  • Thank you received: 0
Hi Dove,

I see you have configured the "ip nat outside" command on the physical interface s0/0. For the frame-relay configuration, did you use only the physical interface or did you use a sub-interface?

Regards,
Krik
Christophe Lemaire
www.exp-networks.be/blog/
  • Page:
  • 1
Time to create page: 0.135 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup