Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: expert need not possible to access the router 871

expert need not possible to access the router 871 5 years 3 weeks ago #37632

  • sais
  • sais's Avatar
  • Offline
  • Frequent Member
  • Posts: 59
  • Karma: 0
for testing some command i tiried in router 871 for some command .


ip dhcp pool don
network 192.168.0.0 255.255.255.0
dns-server
default-router 192.168.0.1
int vlan 1
ip adress 192.168.0.1


line vty 0 4
password bbbb
login

line consol 0
password ddddd
login local
and also conf
username bob privlege 15 password cisco


so when login console it ask for username & password .
when i enter username password it say it say login failed

whn i try telnet router through ip address 192.168.0.1 i can telnet.
go to enable mode . after that it again ask for password which i didnt set ?

what can i do to access router ? and also tired recovery password
rom mode : confreq

after reset & boot command . here also ask for usename and password ?
also whn i enter cmd sh version: here register 0*0 ?

wat will be the solution .
expert advise me.

i can only telnet : as i set dhcp ip in router 871 :
here it ask for enable password ? which i didnt configure .......
The administrator has disabled public write access.

Re: expert need not possible to access the router 871 5 years 3 weeks ago #37635

  • Chris
  • Chris's Avatar
  • Offline
  • Administrator
  • Posts: 1446
  • Thank you received: 13
  • Karma: 8
sais

From what I understand, you have problems trying to obtain access to your router, despite the password recovery which you might have performed.

I'd advise you to follow step-by-step our password recovery article in order to successfully recover your configuration and reset your password(s):

www.firewall.cx/cisco-technical-knowledg...ssword-recovery.html

Good luck!
Chris Partsenidis.
Founder & Editor-in-Chief
www.Firewall.cx
The administrator has disabled public write access.

Re: expert need not possible to access the router 871 5 years 2 weeks ago #37637

  • sais
  • sais's Avatar
  • Offline
  • Frequent Member
  • Posts: 59
  • Karma: 0
i tired password recovery step
1 confreg 0x2142
2 reset
3 boot (its boot ios )

4 step its asking again username password . its not going usermode or privilege mode .

as i set dhcp ip address . i can telnet router . but can go to privilge mode . as it ask enable password which i didnt set .
but whn i enter sh version command .

my register show 0*0 ?
The administrator has disabled public write access.
Time to create page: 0.074 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup