Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: tftp after completing Lab1 Tutorial 2

tftp after completing Lab1 Tutorial 2 9 years 3 months ago #22487

  • fobz
  • fobz's Avatar
  • Offline
  • New Member
  • Posts: 3
  • Karma: 0
After going through Lab1 Tutorial 2 I tried to save the new config to the tftp server. Of course I couldn't, access-list 150 stops everything but port 80 request from Removing the access-list from e0 allowed tftp, ping ect.

I'd like to modify access-list 150 to allow tftp when applied to the interface. adding

access-list 150 permit icmp host host

allows ping request to echo back.

So, I tried adding

access-list 150 permit udp host host eq 69


access-list 150 permit udp host host tftp

neither solved the problem. I also added "log" to access list entries to see the messages, that wasn't a lot of help since I don't really know what I was looking at. Are the numbers in parenthesis after the source and destination addresses ports? i.e. ?

Any help is appreciated.... Thanks
The administrator has disabled public write access.
Time to create page: 0.073 seconds


Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V


  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup