TOPIC: PIX No Route error

Hi all:
i have 4 logical interfaces (vlans) on one physical interface. I can route between 3 of the 4. Any traffic from dmz8 to dmz3 generates this error: %PIX-6-110001: No route to 192.168.3.x from 192.168.8.x

Traffic from dmz1 flows to/from dmz3, 8, & 9 ok
Traffic from dmz3 flows to/from dmz1 & 9 ok
Traffic from dmz8 flows to/from dmz1 & 9 ok
Traffic from dmz9 flows to/from dmz1, 3, & 8 ok

Show route:
dmz1 192.168.1.0 255.255.255.0 192.168.1.254 1 CONNECT static
dmz3 192.168.3.0 255.255.255.0 192.168.3.254 1 CONNECT static
dmz8 192.168.8.0 255.255.255.0 192.168.8.254 1 CONNECT static
dmz9 192.168.9.0 255.255.255.0 192.168.9.254 1 CONNECT static

TIA

Check if you have assigned the same security level to both the interfaces

I double-checked security levels, they are different.

Hi

can you check the static or the nat translation. Also check the access rules for the same since the traffic flow from the high level interface would always be allowed but from a low level it wouold always be restricted.


Sidd

I checked the static, nat, and acl. Any time I have errors in them, I get a "no xlate" or "denied by acl" message instead of "no route" error.

Cisco TAC is baffled too.