Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: How to configure static PAT a range of ports in PIX 501?

How to configure static PAT a range of ports in PIX 501? 13 years 4 months ago #8168

I am using DHCP PPPoE DSL.
I need to configure static PAT to translate port 20000 to 20019 to one PC inside.
Is there a way to configure static PAT of a range with one command line? or I have to PAT each port one by one?

Please kindly suggest. Thank you.

Re: How to configure static PAT a range of ports in PIX 501? 13 years 3 months ago #8196

  • sidd
  • sidd's Avatar
  • Offline
  • Frequent Member
  • Frequent Member
  • Posts: 34
  • Thank you received: 0
The command is

static (inside,outside) tcp interface 20000 x.x.x.x 20000 netmask 255.255.255.255

static (inside,outside) tcp interface 20019 x.x.x.x 20019 netmask 255.255.255.255

Where x.x.x.x is the ip address of the pc on the inside.

Hope this helps...

Sidd

Re: How to configure static PAT a range of ports in PIX 501? 13 years 3 months ago #8200

[code:1]static (inside,outside) tcp interface 20000 x.x.x.x 20000 netmask 255.255.255.255

static (inside,outside) tcp interface 20019 x.x.x.x 20019 netmask 255.255.255.255

[/code:1]

Sidd , correct me if I am wrong but I am not quite sure that by this all the ports ranging from 20000 to 20019 will get translated
  • Page:
  • 1
Time to create page: 0.136 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup