Hot Downloads

Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: PIX - No Layer 3 on interfaces after reload

PIX - No Layer 3 on interfaces after reload 9 years 2 months ago #29798

  • TuftyB
  • TuftyB's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 1
  • Thank you received: 0
I have a PIX 515E and running 7.1(2) software. If I make changes using ASDM I can route traffic through my firewall, but if it reloads there is no IP layer3 on the interfaces even though they are up/up (see below), the start & run config are correct, but if I try and use the CLI through the console to change the interfaces (shut / readd the IP addresss / no shut) it makes no difference. The attached devices see thier interfaces as up/up but the arp-cache is incomplete.
I have to reset back to factory defaults.
Any idea what the issue is

PIX01# sh int ip brie
Interface IP-Address OK? Method Status Protocol
Ethernet0 unassigned YES unset up up
Ethernet0.1 unassigned YES manual up up
Ethernet1 unassigned YES manual up up
Ethernet2 unassigned YES unset administratively down down
Ethernet3 unassigned YES unset administratively down down
Ethernet4 unassigned YES unset administratively down down
Ethernet5 unassigned YES unset administratively down down
PIX01#

Please Log in to join the conversation.

Re: PIX - No Layer 3 on interfaces after reload 9 years 2 months ago #29805

Are you saving your configuration when rebooting? seems a weird problem

Please Log in to join the conversation.

Re: PIX - No Layer 3 on interfaces after reload 9 years 2 months ago #29818

  • S0lo
  • S0lo's Avatar
  • Offline
  • Moderator
  • Moderator
  • Posts: 1577
  • Karma: 3
  • Thank you received: 7
What would be the behavior if you did every thing using the CLI after you reset to factory defaults? I've seen a guy before having problems with saving the config using ASDM. But this one is a little bit strange.

If no use, A post of your final config can help. You could mask out any private info.

Please Log in to join the conversation.

Studying CCNP...

Ammar Muqaddas
Forum Moderator
www.firewall.cx
  • Page:
  • 1
Time to create page: 0.160 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup