Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Question about a PIX 506e

Question about a PIX 506e 10 years 7 months ago #25329

  • Elmer
  • Elmer's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 2
  • Thank you received: 0
Question about a PIX 506e:

I am using PAT since I only have one static IP from my ISP. My question is: is it possible to allow access to my webserver (which is inside the firewall) from the outside, while still allowing web access from the inside?

I can make one or the other work, but not both at the same time--if I use a static statement and ACL I can access the web server from outside, but my web access from inside is trashed. I remove the static and ACL and I can access the web, but (obviously) can't access the web server.

Thanks, any help would be appreciated immensely!

Re: Question about a PIX 506e 10 years 7 months ago #25344

Would need to see the config to be sure but you should be able to have to routes one comming in from the outside and one going out from the inside without a problem.

You may have to get a little fancy with the port numbers but I'd have to see the config to be sure on that.
  • Page:
  • 1
Time to create page: 0.130 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup