Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: PIX 506E (5) SUPPORT

PIX 506E (5) SUPPORT 10 years 6 months ago #25275

I have already established VPN sit to site connectivity with one of our vendors & i dont want that if i create dmz so it effect my vpn connection. Please advice me how to create lan ip range 192.168.1.x t0 192.168.1.20. so i can assign static ip on client machine. ITs really urgent plz , i need ur support

PIX 506E (5) SUPPORT 10 years 6 months ago #25276

INSIDE PIX FIRMWARE

Re: PIX 506E (5) SUPPORT 10 years 6 months ago #25281

You want to NAT your internal IP-Range or what?!
I'm not really getting your question....

If you want to have an internal range of 192.168.1.1-20 then there is no such things as configuring necessary ofcourse.
CCNA / CCNP / CCNA - Security / CCIP / Prince2 / Checkpoint CCSA

Re: PIX 506E (5) SUPPORT 10 years 6 months ago #25345

post the config..


Pix is not a router (it can route) so you set your inside switch to hand off the DHCP address or config each machine staticly. set the route inside to the same net work and you are done.

set the DMZ to a diffrent net say 192.168.2.0 and that should not effect your VPN tunnel.

Set ACLs and NAT to move traffic between interfaces.
  • Page:
  • 1
Time to create page: 0.139 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup