Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: " failover active " comm Primary-Standby or Standb

" failover active " comm Primary-Standby or Standb 11 years 9 months ago #19781

  • zillah
  • zillah's Avatar Topic Author
  • Offline
  • Distinguished Member
  • Distinguished Member
  • Posts: 80
  • Thank you received: 0
I have read these two articles from two different resources

www.informit.com/articles/article.asp?p=24686&rl=1

To force a unit to be the active unit, use the " failover active " command on the Primary-Standby unit, or the " no failover active " command on the Secondary-Active unit.



www.cisco.com/univercd/cc/td/doc/product...ld16icgd/ld16apa.htm

set the " failover active " command to initiate a failover switch from the standby unit, or the " no failover active " command from the active unit to initiate a failover switch.


Isn't failove command issued on a Standby PIX, whether a Standby PIX is primary or secondary ? because in the first article it says : "Primary-Standby"

Re: " failover active " comm Primary-Standby or Standb 11 years 9 months ago #19784

  • Smurf
  • Smurf's Avatar
  • Offline
  • Moderator
  • Moderator
  • Posts: 1390
  • Karma: 1
  • Thank you received: 0
Its irrelevant of the Primary/Secondary, that command is just used for failing over.

If you run the "Failover Active" command on the Standby unit, it will switch it to Active. If you run the no version of the command on the Active unit, it will switch it to Standby.
Wayne Murphy
Firewall.cx Team Member
www.firewall.cx

Now working for a Security Company called Sec-1 Ltd in the UK, for any
Penetration Testing work visit www.sec-1.com or PM me for details.

Re: " failover active " comm Primary-Standby or Standb 11 years 9 months ago #19790

  • zillah
  • zillah's Avatar Topic Author
  • Offline
  • Distinguished Member
  • Distinguished Member
  • Posts: 80
  • Thank you received: 0

Its irrelevant of the Primary/Secondary, that command is just used for failing over.

That means the first article is not accurate.

www.cisco.com/warp/public/110/failover.html#copy

Failover Commands
[no] failover - Enables or disables failover.
[no] failover active - Causes a unit to become active/standby.

  • Page:
  • 1
Time to create page: 0.137 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup