Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: TO CHECK THE TRAFFIC IN ROUTER -871 sh int cmnd ??

TO CHECK THE TRAFFIC IN ROUTER -871 sh int cmnd ?? 4 years 11 months ago #37458

  • sais
  • sais's Avatar
  • Offline
  • Frequent Member
  • Posts: 59
  • Karma: 0
HELLO:
CAN ANY ONE EXPLAIN COMMAND OUTPUT SH INT COMMAND: IT GIVE DETAIL ALL INTERFACE.

HERE HW TO CHECK THE SPEED ? FOR EXAMPLE CUSTOMER REQUEST 1 MB INTERSPEED.
IN ROUTER 871 USING : INTERFACE 4 IS USED FOR WAN CONNECTION .REMAING 1-3 INTERFACE USED LAN CONNECTION ? so u check speed which interface i have see lan or wan interface.

example : here 2 interface output shown :
FastEthernet1 is up, line protocol is up

Hardware is Fast Ethernet, address is e05f.b915.75dd (bia e05f.b915.75dd
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 45000 bits/sec, 52 packets/sec
5 minute output rate 773000 bits/sec, 72 packets/sec
2213051 packets input, 259138106 bytes, 0 no buffer
Received 179385 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
3529981 packets output, 593458624 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out





FastEthernet4 is up, line protocol is up
Hardware is PQII_PRO_UEC, address is e05f.b915.75e0 (bia e05f.b915.75e0)
Description: (( WIMAX SU ))
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 774000 bits/sec, 75 packets/sec
5 minute output rate 41000 bits/sec, 49 packets/sec
3605203 packets input, 605724146 bytes
Received 117843 broadcasts, 0 runts, 0 giants, 0 throttles
7 input errors, 7 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
1979656 packets output, 216655115 bytes, 0 underruns
0 output errors, 0 collisions, 5 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out


Vlan1 is up, line protocol is up
Hardware is EtherSVI, address is e05f.b915.75dc
Internet address is 8
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 42000 bits/sec, 52 packets/sec
5 minute output rate 777000 bits/sec, 70 packets/sec
2212275 packets input, 249613664 bytes, 0 no buffer
Received 179189 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
3491684 packets output, 578921772 bytes, 0 underruns
0 output errors, 1 interface resets
106724 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
The administrator has disabled public write access.

Re: TO CHECK THE TRAFFIC IN ROUTER -871 sh int cmnd ?? 4 years 11 months ago #37470

  • sais
  • sais's Avatar
  • Offline
  • Frequent Member
  • Posts: 59
  • Karma: 0
expert pls explain sh int commands?
The administrator has disabled public write access.

Re: TO CHECK THE TRAFFIC IN ROUTER -871 sh int cmnd ?? 4 years 11 months ago #37472

  • TheBishop
  • TheBishop's Avatar
  • Offline
  • Moderator
  • Posts: 1719
  • Thank you received: 8
  • Karma: 5
Please post the sh int output for the interface that provides the WAN connection. If you're not sure which that is, try s sh int summary, sh int brief or sh int status and post us that
The administrator has disabled public write access.

Re: TO CHECK THE TRAFFIC IN ROUTER -871 sh int cmnd ?? 4 years 11 months ago #37477

  • sais
  • sais's Avatar
  • Offline
  • Frequent Member
  • Posts: 59
  • Karma: 0
*: interface is up
IHQ: pkts in input hold queue IQD: pkts dropped from input queue
OHQ: pkts in output hold queue OQD: pkts dropped from output queue
RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)
sh int summary.

TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)
TRTL: throttle count

Interface IHQ IQD OHQ OQD RXBS RXPS TXBS TXPS TRTL
FastEthernet0 0 0 0 0 0 0 0 0 0
FastEthernet1 0 0 0 0 6000 3 206000 4 0
FastEthernet2 0 0 0 0 0 0 0 0 0
FastEthernet3 0 0 0 0 0 0 0 0 0
FastEthernet4 0 0 0 0 207000 6 6000 4 0
FastEthernet4.341 - - - - - - - - -
NVI0 0 0 0 0 0 0 0 0 0
Vlan1 0 0 0 1 6000 3 206000 3 0
OTE:No separate counters are maintained for subinterfaces
Hence Details of subinterface are not shown


wan interface output ?

FastEthernet4 is up, line protocol is up
Hardware is PQII_PRO_UEC, address is e05f.b915.75e0 (bia e05f.b915.75e0)
Description: (( WIMAX SU ))
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 1., loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 137000 bits/sec, 14 packets/sec
5 minute output rate 16000 bits/sec, 13 packets/sec
5995250 packets input, 3829706918 bytes
Received 312240 broadcasts, 0 runts, 0 giants, 0 throttles
11 input errors, 11 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog
0 input packets with dribble condition detected
3261223 packets output, 329118917 bytes, 0 underruns
0 output errors, 0 collisions, 5 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
FastEthernet4.341 is up, line protocol is up
Hardware is PQII_PRO_UEC, address is e05f.b915.75e0 (bia e05f.b915.75e0)
--More--
The administrator has disabled public write access.
Time to create page: 0.084 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup