Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: 3500xl

3500xl 9 years 15 hours ago #32196

  • mic
  • mic's Avatar Topic Author
  • Offline
  • Frequent Member
  • Frequent Member
  • Posts: 28
  • Thank you received: 0
hello everyone thanks for help, i got 3500xl switch with lost password, i did perform the tasks to the recovery, which is posted -flash_init, load_helper,dr flash:, rename, boot, enable, rename again back, but when i get to last step copy flash:config.text system:running-config it ask for a confirm by, then starts to look for a domain till times out, anybody got any thing that might help me ,, thanks much Boe??

Re: 3500xl 8 years 11 months ago #32235

  • S0lo
  • S0lo's Avatar
  • Offline
  • Moderator
  • Moderator
  • Posts: 1577
  • Karma: 3
  • Thank you received: 7
For the last command, it should show an output like this:

[code:1]Switch# copy flash:config.text system:running-config
Destination filename [running-config]? [/code:1]

For the destination file, just press enter. if you did so, can show us the exact output that your getting?
Studying CCNP...

Ammar Muqaddas
Forum Moderator
www.firewall.cx

recovery 8 years 11 months ago #32243

  • mic
  • mic's Avatar Topic Author
  • Offline
  • Frequent Member
  • Frequent Member
  • Posts: 28
  • Thank you received: 0
Switch>en
Switch#rename flash:config.old flash:config.text
Destination filename [config.text]?
Switch#copy flash:config.text system:running-config
Destination filename [running-config]?
1832 bytes copied in 1.311 secs (1832 bytes/sec)
Switch#
00:05:25: %SYS-5-CONFIG: Configured from by---(if dont give name)
then if starts to look for server, it must be connected to AAA server tacs and some how when i tranfer the first time config.text to config.old before tranfer back it must carry some information with it, is there a work around for this, thank you for the reply, mic

PS. got this from someone it was not setup here

finnaly 8 years 11 months ago #32244

  • mic
  • mic's Avatar Topic Author
  • Offline
  • Frequent Member
  • Frequent Member
  • Posts: 28
  • Thank you received: 0
got it put new config.text file in, thanks for help, mic
  • Page:
  • 1
Time to create page: 0.140 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup