Hot Downloads

Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Dynamic NAT!

Dynamic NAT! 8 years 11 months ago #30808

  • redst
  • redst's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 8
  • Thank you received: 0
Hi its me again,
just have a question,when using DNAT,like how many public ip's i can put on pool, let's say i was given like 15 public ip's how can i put it,like is there a short cut command w/out typing all those 15 ip's?..
thanks..

Please Log in to join the conversation.

Re: Dynamic NAT! 8 years 11 months ago #30811

  • S0lo
  • S0lo's Avatar
  • Offline
  • Moderator
  • Moderator
  • Posts: 1577
  • Karma: 3
  • Thank you received: 7
I assume that your considering Cisco router configuration here. You would specify the start and end IPs. Say you have 15 IPs from 150.1.1.1 to 150.1.1.15. The pool's config would look like this:

[code:1]ip nat pool POOL1 150.1.1.1 150.1.1.15 netmask 255.255.255.240[/code:1]

Here is a complete article describing Dynamic NAT configuration:

www.firewall.cx/tk-cisco-routers-nat-dynamic.php

Please Log in to join the conversation.

Studying CCNP...

Ammar Muqaddas
Forum Moderator
www.firewall.cx
  • Page:
  • 1
Time to create page: 0.146 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup