Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: Bandwidth Control for ISPs

Bandwidth Control for ISPs 9 years 7 months ago #28531

  • Alans
  • Alans's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 230
  • Thank you received: 1
Hi,
I want to know how ISP allocate bandwidths for each client?
like they have a client with 128 DL kbps and another with 512 kbps DL

Another question (related): is that possible to use Frame Relay between a router and a LAN? I mean if we have a LAN with Exchange server for example and other servers, how can I limit the bandwidth for each server from the router?
Is that possible to use Frame Relay from the router that connected to same switch of servers?

regards,

Re: Bandwidth Control for ISPs 9 years 7 months ago #28532

It would depend on the WAN access technology being used. i.e. for FR / ATM you can set a CIR / PIR on the PVC, for Ethernet you can use Layer 2 rate limiting on the VLAN. Or if you wish to supply a full speed circuit you can limit at certain point or your network, like the egress edge - customers would have full speed within your network and then be limited as they leave, you can do this with a Layer 7 policing box - like the Cisco SCE.

For your other question I would use Ethernet and rate limit per VLAN.

Re: Bandwidth Control for ISPs 9 years 7 months ago #28538

  • Alans
  • Alans's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 230
  • Thank you received: 1
Thanks.. but rate limit will not let us to use less than 1 M..
what if i want to limit each server to 128 kbps?

Re: Bandwidth Control for ISPs 9 years 7 months ago #28539

where do you get the 1mb limit? on my 1720 the minimum input/output rate limit value on a fastethernet subinterface is 8000 bits.

Re: Bandwidth Control for ISPs 9 years 7 months ago #28540

  • Alans
  • Alans's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
  • Posts: 230
  • Thank you received: 1
i saw it in some websites..i think thye used srr ...etc comand
could you please be more specific like show me commands and how to control both inbound and outbound connections on a certain port on the switch?

Re: Bandwidth Control for ISPs 9 years 7 months ago #28577

maybe (: what switch / router model are you doing this on?
  • Page:
  • 1
  • 2
Time to create page: 0.133 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup