Hot Downloads

Welcome, Guest
Username: Password: Remember me

TOPIC: NAT

NAT 9 years 4 months ago #21564

suppost i have one router whose one port is connected to the internet ie by isp and another port by the switch . and with switch i have connected my ten pc .
The address given by the isp is 200.1.1.25 ok. and now i have to do the natting so what to do.
pls reply fast
The administrator has disabled public write access.

Re: NAT 9 years 4 months ago #21591

  • anti-hack
  • anti-hack's Avatar
  • Offline
  • Frequent Member
  • Posts: 38
  • Karma: 0
hi,

you have to configure the router to PAT all the hosts to one IP address of your serial interface,

normally it goes like this;

in global configuration mode;

access-list 20 permit 192.168.1.0 0.0.0.255
ip nat inside source list 20 interface Serial0 overload

on the serial interface;

ip nat outside

on the ethernet interface;

ip nat inside

thats just about it, this is all assuming that you have one IP address and everyone is going to use it, if you ave pool then things would be slightly different.
The administrator has disabled public write access.
Time to create page: 0.078 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup