Hot Downloads

×

Notice

The forum is in read only mode.
Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: How to enable VPN to my domaincontroller on my router

How to enable VPN to my domaincontroller on my router 12 years 6 months ago #13549

  • sniek
  • sniek's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 1
  • Thank you received: 0
Dear forumusers,

Since a few days I've been trying to set up a VPN passthrough on my Cisco 876 ADSLoverISDN router.

VPN works fine, but the router refuses connections from outside. WHICH IS GREAT. However, I would like to enable VPN and REMOTE desktop acces from outside connections.

CISCO help is not very helpfull and I hope someone in here can help me get a long. Since even pinging my IP adres gives me timeout errors I've been looking in to the firewall options. Does not seem to help to open it up completely even.

regards,
Tommie

Re: How to enable VPN to my domaincontroller on my router 12 years 5 months ago #13738

I am not aware of your router series, But my suggestion is first confirm
" Did u enabled NATing in your router" if so, you have to check the NAT configuration.
If you are not enabled NAT , Check that IP route entry you are using for VPN is available in or not.
All are Ok still problem,

Check the local server there might be not enabled VPN and remote access.
Still problem ask me , i will solve u r problem, But make sure above mentioned solutions.
Suresh
  • Page:
  • 1
Time to create page: 0.122 seconds

CCENT/CCNA

Cisco Routers

  • SSL WebVPN
  • Securing Routers
  • Policy Based Routing
  • Router on-a-Stick

VPN Security

  • Understand DMVPN
  • GRE/IPSec Configuration
  • Site-to-Site IPSec VPN
  • IPSec Modes

Cisco Help

  • VPN Client Windows 8
  • VPN Client Windows 7
  • CCP Display Problem
  • Cisco Support App.

Windows 2012

  • New Features
  • Licensing
  • Hyper-V / VDI
  • Install Hyper-V

Linux

  • File Permissions
  • Webmin
  • Groups - Users
  • Samba Setup